After the application server is installed and the applications
are deployed, install the web server plug-in on the HTTP server.
This procedure assumes that the HTTP server is on a node that is
not in the cluster.
On the web server computer (the remote system that has
HTTP server installed),go to the WebSphere Network Deployment installer
directory and run Launch Pad by typing the appropriate command:
From Launch Pad, select Launch the installation wizard for Web server plug-ins.
Deselect Installation roadmap and Plug-ins section of the Getting Started guide,
and then click Next.
Select I accept both the IBM and the non-IBM terms and
click Next. The installer will now check your system.
On the System Prerequisites Check screen, click Next.
If your system passes the prerequisites check, click Next.
Note: If your system does not pass the prerequisites
check, stop the installation, correct any problems, and restart
the installation.
Select IBM HTTP Server V7 and click Next.
Select Web server machine (remote) and click Next.
Specify the [plugins_root] directory and the location
where the web server plug-ins should be installed, and click Next.
In Select the existing IBM HTTP Server httpd.conf file,
click Browse and select the httpd.conf file from the [webserver root]/conf
directory, where [webserver root] specifies the directory
where IBM HTTP Server is installed.
In the Specify the Web server port box, keep the default
port value of 80 and click Next.
In the Specify a unique Web server definition name box,
enter a unique identifier for this definition and then click Next.
In the Web server plugin-cfg.xml file box, accept
the default settings and then click Next.
In the Host name or IP address for the Application Server box,
type the host name or IP address of the ND node and then click Next.
In the confirmation pane, click Next and, in the summary
information pane, click Next.
After the the web server plug-in is installed and copied,
click Next and then click Finish.
Copy the appropriate file from IBM HTTP Server <plugin_dir>/bin
to the WebSphere Network Deployment [appserver root]\bin
folder:
(Windows) configure[webserver definition name].bat.
For example, configureserver1.bat
(Linux/UNIX) configure[webserver definition name].sh
Ensure that Deployment Manager is running and then run configure<webserver definition name>.bat
for Windows or configure<webserver definition name>.sh
for Linux or UNIX on the WebSphere Network Deployment computer to
create an unmanaged node on the WebSphere Network Deployment computer
and add the web server to it.
Log in to the WebSphere Administrative Console and, in the
navigation tree, click Servers > Web servers and then,
click web server name. Under Additional Properties click Remote Web server management.
Ensure that Port, Username and Password details are the same as
provided for IBM HTTP Administration server.
Click
Servers > Web servers and then, in the right
pane, Select check box beside the web server name. Click
Start.Before
performing above step,
Note: ensure that IBM HTTP Administration
Server is running on the remote machine (IBM HTTP Server machine)
Open a web browser and access the administrative console
for the web server computer (http://[web server name]:80/adminui)
to verify whether the plug-in generated and propagated successfully.
The following response indicates that you must generate and propagate
the plug-in as described in steps 21 to 24:
/[application name] not defined
Note: The plug-in generates and propagates automatically
only if your system previously enabled automatic synchronization,
which is disabled by default.
Log in to the WebSphere Administrative Console and, in the
navigation tree, click Servers > Web servers and
then, in the right pane, select the Select check box beside
the HTTP server name.
Click Generate Plug-in. A message confirms successful
generation of the Plugin-cfg.xml file.
Click Propagate Plug-in. A message confirms successful
propagation of the Plugin-cfg.xml file.
Restart the web server.
