|
Output supports two modes of caching:
If you switch between cache modes, restart the Output service
for the change to take effect. To restart this service, either use
Workbench or see Start or stop the services associated with LiveCycle modules for
instructions.
The cache check point time is reset automatically when you switch
between modes.
Using unconditional cachingIn this mode, when the Output service receives a request,
it validates the resources (form design and any related assets such
as fragments and images) that are required. The Output service compares
the timestamp of the resources in the repository to the timestamp
of the resources in the cache. If the resource in the cache is older,
the Output service updates it.
This cache mode guarantees that the most recent resources are
used. However, performance is affected because the Output service
validates the cached items against the repository with each request.
This cache mode is suitable for development and staging environments
where resources are updated frequently and performance is not a
primary concern.
Specify unconditional cachingIn Administration Console,
click Services > LiveCycle Output 11.
Under Output Cache Control Settings, select Unconditionally
and click Save.
Use the cache check pointIn this mode, the Output service only checks the repository
for newer versions of resources when the timestamp of the cached
resource is older than the cache check point time. The last cache
check point time is displayed on the Output page in Administration
Console.
Use this cache mode in high-performance production environments
where performance is a concern and changes to resources are infrequent.
You can reset the cache check point time when you want to deploy
any changes made to the repository resources.
Specify the use of a cache check pointIn Administration
Console, click Services > LiveCycle Output 11.
Under Output Cache Control Settings, select Only If Their
Last Validation Was Done Prior To Cache Check Point Time and click
Save.
Reset the cache check pointIn Administration Console,
click Services > LiveCycle Output 11.
Under Output Cache Control Settings, click Cache Check Point.
Reset the cache contentsYou can clear the contents of the cache at any time. After
a cache reset, the first request for each form is slower because
the Output service performs a complete rendering and creates new
cache content.
In Administration Console, click Services > LiveCycle
Output 11.
Under Output Cache Control Settings, click Reset Cache.
|
|
|
